Cunningham Penile Incontinence Clamp, Regular 2″. Used to control stress incontinence or dribbling of urine. Constructed of soft sponge rubber and can be adjusted to fit comfortably. Single-use, non-sterile
Cunningham Penile Incontinence Clamp, Regular 2". Used to control stress Incontinence or dribbling of urine. Constructed of soft sponge rubber and can be adjusted to fit comfortably. Single-use, non-sterile.
Product Features & Benefits
- Reusable and washable.
- Adjustable fitting.
- Effective control of stress incontinence, enuresis or bed wetting.
- Suitable for use with males of all ages.
Product Specifications
- Product Numbers: 57004053
- Size Options: Regular
- Sizes:1 - (1-1/2 inch), Size 2 - (2 inch) or Size 3 - (3 inch).
- Materials: Steel, foam and latex.
- Application: Control stress incontinence.
- Non-sterile.
- Replace every 3 months or when there are signs of deterioration, cracking, discoloration or separation of foam.
- Manufacturer: Bard Medical.
- HCPCS Code: A4356.
- UNSPSC Code: 42291802.
Product Sizing is by penis shaft circumference, not length. Three sizes are available--large, regular or juvenile. Most men use the size 2. Below is a guide to help you to select the best clamp size to meet your needs.
- Step 1: measure the circumference of your penis with a tape measure.
- Step 2: select the size that best meets your circumference measurement.
- If your circumference measurement is 3 inches or more, select the large clamp.
- If your circumference measurement is around 2 inches, select the regular clamp.
- If your circumference measurement is around 1-1/2 inches, select the juvenile clamp.
How to Properly Apply
- Step 1: Place the clamp about halfway down the shaft of your penis between the two foam pads.
- Step 2: Tighten the clamp to compress your urethra. Use the ratchet catch to adjust the pressure. This is what stops urine flow. The large and regular clamps each have 5 settings that adjust the pressure on your urethra. To release the catch, press inward on both of the spring wire loops. The juvenile clamp is not adjustable.
- Step 3: Loosen your clamp every 1 to 2 hours to allow urine to flow. Going beyond 2 hours places you at higher risk of contracting a urinary tract infection. Reposition the clamp slightly up or down the shaft or you penis so that it is not in the same place as before.
- Do not use at night while you are sleeping.
- Step 4: Ensure that the clamp is not set too tightly, cutting off blood circulation or causing skin irritation.
Cleaning Tips and Tricks
- Wash in a sink with mild soapy water.
- Rinse thoroughly with clean water.
- Gently squeeze the foam to get rid of excess water.
- Air dry at room temperature away from excess heat or direct sunlight.
- Do not use bleach, detergent, or hot water on your clamp.
- Do not put in the washer or dryer
- Do not use a blow dryer on the clamp.
